Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 217)

217 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The redraw function is used when
Show Path has been chosen in the
configuration and the path that you
have followed is shown on the graphi-
cal area of the display.
When moving around in the same
area, this graphical area may not
refresh. The path may build up
obscuring the display.
Press REDRW (F4) to refresh the
display and erase the displayed path.
7.5.7 Using the Redraw function 7.5.8 Picking up a new point
This function is available in Advanced
mode. If you are staking out and need
to measure new points, you may do
so by pressing the PCKUP (F5) key.
This brings you into survey mode.
Measure the points and/or hidden
points as described in sections 7.4.6
and 7.4.9.
Press SHIFT and then STAKE (F2) to
return to Stake-Out. Returning to
Stake-Out is possible before a point
occupation or after storing the point.
7.5.9 Using the INIT key
The INIT (F6) key is available in
Advanced mode and is used to select
and force a new initialization.
In Stake-Out, the initialization will
always be on-the-fly. More details
about using the INIT key and
initialization on the fly can be found in
section 7.4.8.