Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 289)

289 11. Applications Technical Reference Manual-4.0.0en
Any existing Wake-up Sessions are
displayed.
Use NEW (F2) to enter a new Wake-
up Session.
Use EDIT (F3) to edit an existing
Wake-up Session.
Use DEL (F4) to delete an existing
Wake-up session.
When NEW (F2) is pressed the
following screen appears.
Job - Select the job which should be
used to record the point(s)/data.
Config Set - Select the Configuration
Set which should be used.
Start Date - Enter the date when the
Session should start.
Start Time - Enter the Start Time
when the Session should start.
Duration - Enter the duration of the
Session.
Point Id - If the wake-up session will
be carried out on a known point,
select it from the listbox.
If it will be carried out on an unknown
point, leave it set at ---. Define a Point
Id template in the Configuration Set.
Define a name alone, without any
automatic increment if you always
wish the point to have the same point
ID. Define a name with an automatic
increment if you wish the point to
have a different Point ID for each
wake-up session.
Ant Height - Enter the height of the
Antenna above the point.
# Execute - The number of times that
you wish to repeat this Wake-Up
session.
Interval - Appears when # Execute is
set to a value greater than 1. Defines
the time interval that must elapse
between start times of the different
executions of the Session.