Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 248)

248 9. The CONFIG Key Technical Reference Manual-4.0.0en
For information about Real-Time
Rover parameters refer to section 5.4
Con-figuring the Receiver for Real-
Time Rover Operations.
9.11 Interfaces - NMEA Output
The NMEA Output interface enables
you to configure which NMEA
messages to output through which port
using which device.
Set the focus on NMEA Output and
press EDIT (F3) to select the NMEA
messages to be output.
Select the port to which the NMEA
messages should be sent. Use the
DEVCE (F5) key to configure the
device itself. Refer to Appendix H for a
complete list of all supported devices.
Use the ID (F4) key to define the talker
ID that appears at the beginning of
each message. This will normally
remain at the default GP for GPS.
Use the MESGS (F3) key to display
the messages that can be output, the
rates and the output timing method.
Highlight the message that is to be
output and press F3 (EDIT) to
configure how a particular message is
sent.
Rate - Choose a rate between 0.1
and 3600s at which the message
should be sent.