Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 236)

236 8. Coding Technical Reference Manual-4.0.0en
8.1.4 Adding a Thematical Code to a Point
When a Thematical Codelist has
been selected for use within a Con-
figuration Set, it will be possible to
add a Thematical Code to a point
when measuring.
The fields Point Code and Code
Name will be displayed as above.
Highlight the Point Code and either:
1. Use the left or right cursor keys to
cycle through the code list.
or
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
The Code Name will be displayed for
the Point Code that you have cho-
sen. Enter any attributes for the code
using the ATRIB (F4) key.
The code is stored along with the
Point Id information.
When the Point Code list box is open
there are several other operations
that you may carry out.
CONT (F1) selects the code and
returns to the survey screen.
NEW (F2) lets you define a new code.
LAST (F3) jumps to the code log and
displays the codes that were last
assigned in order.
ATRIB (F4) - lets you define attributes
for the selected code and add attribute
values to the choicelist of an attribute.
To add an attribute value to a
choicelist, highlight the line of the
according attribute and press ENTER.
Type in the new attribute value, then
press ADD (F2).
STORE (F1) records the code and
returns to the Main Survey panel.