Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 120)

120 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Formats
You can configure the way in which
information is presented when
surveying.
Format Grid - The format of grid
coordinates if they are being used.
Format Geodetic - The format of
geodetic coordinates if they are being
used.
Quality Type - The way in which the
quality of a position is displayed in the
Main Survey screen. This is Hard-
wired to DOP for Real-Time
Reference Configurations. It will
display a Dilution of Precision
according to the components defined.
Defined by - Defines the components
used to calculate the DOP. The
definitions of the DOP are as follows:
Height - VDOP
Pos - HDOP
Pos + Hgt - PDOP
Pos + Hgt + Time - GDOP
OCUPY Counter - Defines how the
length of time spent occupying a point
is displayed. Select from Time -
normal time or Observations - the
number of computed navigation
solutions recorded.
Coding
Normally, when setting up a Real-
Time Reference Station, the
Reference Point will be selected from
a predefined point list. These points
will have been measured previously
and any required code already
assigned. Therefore a Coding System
is not usually required.
If you still wish to select a coding
system press ENTER and choose
from Thematical or Free coding.
Complete descriptions of the coding
systems used by System 500 are
given in Section 8.
Press CODES (F3) to review the
codes in the chosen codelist. You
may also edit the codelist here.