Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 111)

111
5. Configuring the Receiver Technical Reference Manual-4.0.0en
You now wish to survey one individual point and give
it the point ID “BM98”. In the Survey panel, enter this
point ID. Survey this point and upon pressing
STORE, the next point Id will revert back to
“Point0002”.
Note - When entering the individual point Id “BM98”
you did not need to press SHIFT INDIV (F5) as in
Working Example 1. This is because the “Point####”
template is operating in the Change to Individual
mode.
Suppose you do now wish to survey points using a
new point Id “###Fence” and you wish this template
to operate in the Remain Running mode.
Enter the point Id “001Fence” and then press SHIFT
RUN (F5). Occupy and store this point. The next
point Id will be “002Fence”
Field Proc
(cont) -
Working Example 2 (cont)
Note: Numerical characters in front of any text will also increment. This allows any type of
incrementing point Ids to be created.