Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 165)

165 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The line Time to go changes to
Static Obs/Time.
Static Obs/Time - The method by
which you have selected to count
time will be shown. In Advanced
mode, you may select to display the
amount of data required according to
one of four criteria. If this has been
set, a percentage value will be shown
next to the expired Epochs/Time.
This percentage value is the amount
of data recorded with 100% being the
amount required. If Auto Stop was
selected, the recording of
observations will automatically stop
when 100% is reached.
The ADD (F5) key is available.
Further information is available in the
next section.
Further information about the Stop
and Go indicator, satellites tracked,
data logged etc. can be accessed
through the STATUS key. More
information about this key is given in
Chapter 10.
When the required length of time has
passed, press the STOP (F1) key to
stop raw observation recording. If
Auto Stop has been set in the
Configuration, this will happen
automatically.
Press STORE (F1) to store the Point
Id and any Thematical Code that you
may have assigned. If Auto Store has
been set in the Configuration, this will
happen automatically.
Once the point is stored, again the
OCUPY (F1) key becomes available
and the start time line is shown with
the current time and the seconds
rounded to zero. To start a new
occupation enter the next start time.
Then press OCUPY (F1).
Leave the survey by pressing SHIFT
followed by QUIT (F6). To switch off,
press the ON/OFF key on the
terminal.