Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 184)

184 7. Measuring with System 500 Technical Reference Manual-4.0.0en
It will be possible to add a code to a
point if a coding system has been
defined for use in the Configuration
Set.
System 500 supports two coding
methods; Thematical Coding and
Free Coding. The principles of both
methods of coding are explained in
Chapter 8.
Thematical Coding
The fields Point Code and Code
Name will be displayed as above.
Highlight the Point Code and either:
1. Use the left or right cursor keys to
cycle through the code list.
or
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
The Code Name will be displayed for
the Point Code that you have
chosen. Enter any attributes for the
code using the ATRIB (F4) key.
The code is stored then along with
the Point Id information.
Auto-logged points may also be
coded if a coding system has been
defined. The procedure will be the
same as with Occupy Points
described above.
For further information on how to use
codes with Auto-logged Points refer
to chapter 7.4.7 Using the AUTO key.
Free Coding
The Last Code and second last
code (2Last Code) that were used
are shown.
The CODE (F4) key will be available.
Press this key to access the codelist.
7.4.4 Adding a Code