Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 129)

129
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Use the DEFLT (F5) key to reveal
default antenna configurations with
current Leica GPS antennas. This will
then change to ALL. Use ALL (F5) to
reveal System 300 antenna
configurations also. You can pick out
the antenna configurations that you
will use the most and delete the rest.
All possible antenna configurations
may still be accessed in the future by
using the DEFLT and ALL keys. Position
This screen defines the rate for and
the way in which position is displayed.
If you wish to work in local
coordinates, you MUST define the
coordinate system here.
Update Rate - Defines the rate at
which the position will be updated on
the display.
Coord Sys - You may also select a
coordinate system which will be used
to display the positions. The WGS84
coordinate system will always be
available. You may define other
coordinate systems in Applications
in Determine Coord System (see
section 11.1).
Highlight Coord Sys and press
ENTER to reveal the list of coordinate
systems currently available.
Select the coordinate system that you
wish to use.
Use NEW (F2) to define a new
coordinate system. Use EDIT (F3) to
edit a coordinate system. Use DEL
(F4) to delete the selected coordinate
system and INFO (F5) to reveal the
type of transformation used.
When NEW (F2) is pressed, the
following screen appears.