Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 32)

32 2. Set-up and Connection Technical Reference Manual-4.0.0en
Use
Post-processed Kinematic Rover.
The TR500 is mounted on the Receiver which is screwed
onto the pole grip. One connection is made from the
Receiver to the Antenna. Recommended for short periods
of use, especially where there are many obstacles (fences
etc.).
Assumptions
1. GPS Antenna is mounted directly using screw fitting.
If using stub and GAD 31 adapter, procedures may
vary slightly.
2. Aluminium poles are used. You may replace them
with their Carbon Fiber equivalents without any
change to these instructions.
2.5 Equipment Setup - Post Processed Kinematic, All on Pole, Direct Clip of TR500 on to Sensor