Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 161)

161 7. Measuring with System 500 Technical Reference Manual-4.0.0en
To break the auto numbering press
Shift INDIV (F5) and enter an indi-
vidual Point Id. After this point has
been stored it will return to the previ-
ously suggested Point Id.
If you define a Point Id Template in
the Configuration Set you have even
more flexibility to automatically define
your Point Id’s.
Further information about Point Id
Templates and two working examples
are given in Chapter 5.2.
It will be possible to add a code to a
point if a coding system has been
defined for use in the Configuration
Set.
System 500 supports two coding
methods; Thematical Coding and
Free Coding. Both methods of coding
are explained in Chapter 8.
Thematical Coding
The fields Point Code and Code
Name will be displayed as above.
Highlight the Point Code and either:
1. Use the left or right cursor keys to
cycle through the code list.
or
7.1.4 Adding a Code 7.1.3 Adding the Antenna Height
Measure the Antenna Height. When
using a Tripod this will be measured
using the Height Hook. When
mounted on a pillar, you must use
some other way of measuring the
height. Enter the value in Ant Height.
Further details on measuring the
Antenna height can be found in
section 2.15.