Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 127)

127
5. Configuring the Receiver Technical Reference Manual-4.0.0en
5.4 Configuring the Receiver for Real-Time Rover Operations
This section covers configuration of
the receiver for Real-Time
Rover Operations. Note that Real
Time Rover Operations are only
possible with an SR530 (Real-Time to
centimeter level) or an SR510 or 520
that has the RTCM 2.0 option
activated (DGPS to 0.5 - 5m level).
Highlight the Configuration Set you
wish to edit and press EDIT (F3).
Note that you cannot edit default
Configuration Sets. You have to
create a new Set and then edit it. If
the only existing Configuration Sets
are default Sets, highlight the Set that
corresponds to the type of operation
you wish to configure (in this case,
RT_ROV), and press NEW (F2).
After entering the Name, etc., select
the new Configuration Set and press
EDIT (F3).
Operation Mode
Select the Operation Mode that you
require. The Operation Mode defines
which Configuration screens will be
available to you.
You may choose between Standard
and Advanced. Standard is
recommended for most users.
Advanced enables definition of
parameters required for scientific
research and other specialized
applications.
When you have made your selection
press CONT (F1) to go through the
fixed order of parameter panels.
Or press LIST (F6) to get a listing of
the available parameter panels which
can then be accessed individually
with CONT (F1). Changes are
automatically stored at the end of the
list. Changes in individual parameter
panels can be stored with STORE
(F3) without the need to go to the end
of the list.
The Standard Operation mode is
described from here on. The extra
configurable features available when
Advanced is selected are described in
the next section.