Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 286)

286 11. Applications Technical Reference Manual-4.0.0en
When a Configuration Set is being
used where Advanced mode is set,
the averaging functionality in
Threshold Settings is set to Abs and
the point contains more than one
measurement, then the ABS (F6) key
is available.
Press USE (F2) to include or exclude
a measurement from calculating the
absolute coordinate difference. An
absolute coordinate difference can
only be calculated between two
measurements.
Press DIFF (F3) after having set the
use flag for two measurements, to
display the absolute coordinate
differences.
The absolute differences for Easting,
Northing and Height can only be
displayed if the survey is carried out
in a local coordinate system.
An asterisk identifies those which
exceed the threshold settings.
CONT (F1) returns you to the previ-
ous screen.
Press DEL (F4) to delete single
measurements.
CONT (F1) to return to Edit Point
screen.
CONT (F1) returns to the listing of
points of the current job.
When SHIFT is pressed the JOB (F3)
key enables you to change the
current job. Note - this function is not
available if you access Point
Management with a Hot-Key.
When SHIFT is pressed the FILT (F6)
key is available along with the stan-
dard HOME, END, PG UP and PG
DN keys.
Use FILT (F6) to order the points and
to apply a filter to the points.
Sort By - Sets the method by which
the points are ordered. Point Id sorts
alphabetically, Time by the time the
point was calculated and Internal
Index by the order in which they are
stored on the memory device.