Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 201)

201 7. Measuring with System 500 Technical Reference Manual-4.0.0en
Double Distance, height included
If the height computation for a
hidden point has been enabled
within the configuration, the following
options apply in addition to those on
the previous page.
Delta Hgt - Height difference
between the center of the external
device and the aimed point.
Devices with inclinometer like the
Laser Locator will transfer the
measured height difference
automatically into this field as long
as Include Hgt in the panel
CONFIGURE\ Hidden Point is set
to YES.
When working with devices without
inclinometer the height difference
can be estimated and typed in
manuallly.
Use the I/T H (F4) key to check or
enter the instrument height at the
standpoints A and B and target
heights.
The default values as defined in the
configuration are displayed but can
be edited. Use the DEFLT (F5) key to
reveal the default values again.
Trgt Height will only be available if
the settings have been done
accordingly in the configuration.
Otherwise, only the instrument height
will be taken into account.
CONT (F1) to return to the previous
panel.
When Distance A or Distance B is
highlighted, use SLOPE (F5) to
enter a slope distance and either an
elevation angle or a grade in %.
External devices work here as well.
CONT (F1) returns to the previous
panel and displays the calculated
horizontal distances and height
differences.
For further information on the Hidden
Point application and configuration
refer to Appendix H as well as
chapter 5.4.1.