Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 95)

95
5. Configuring the Receiver Technical Reference Manual-4.0.0en
The Advanced Mode contains extra
configurable parameters that may be
required for certain specialized
applications.
Select Advanced in
CONFIGURE\Operation Mode.
Only the screens that differ from
those seen in Standard Mode are
described here.
Position
In addition to the functionality given in
Standard mode, details about the
chosen coordinate system are given.
Residuals - Available when editing a
coordinate system. The method by
which residuals will be distributed
throughout the transformation area is
displayed.
This may help the transformation
result be more realistic and help
disperse any strains in the
transformation. 1/Dist, 1/Dist
2 and 1/
Dist 3/2 distributes the residuals of the
control points according to the
distance between each control point
and the newly transformed point.
5.1.1 Advanced Operation Mode for Static and Rapid Static
Multiquadratic distributes the
residuals using a multiquadratic
interpolation approach.
Transform - The name of the
transformation set used is displayed.
Ellipsoid - The name of the local
ellipsoid is displayed.
Projection -The name of the
projection used is displayed.
Geoid Model - The name of the
geoid model used is displayed.
CSCS Model - The name of the
CSCS model used is displayed.
Note that the details that are
displayed depend upon the type of
transformation used. Certain types of
transformation do not use all of the
described parameters to calculate
local coordinates.