Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 347)

347 Appendix H Technical Reference Manual-4.0.0en
To enter a new GSM station, highlight
Station in panel CONFIGURE\ GSM
Station and press ENTER.
All existing stations are listed. To edit
a station, highlight it and press EDIT
(F3). To delete a station, highlight it
and press DEL (F4). To enter a new
station, press NEW (F2).
The SCAN functionality can be used
to check the data format of a GSM
reference. Pressing SCAN (F5)
establishes a connection to the GSM
reference. The reference station id,
the data format used for transmitting
and the latency (time delay) of the
GSM reference station is displayed.
CONT (F1) cuts the GSM connection
and returns to the previous panel.
The station id of the highlighted
reference station is taken over into
the Ref Stn Id line, if Accept Ref is
set to User defined.
Enter the Station name, telephone
Number and the type of GSM Proto-
col (Analog, ISDN V.110 or ISDN
V.120). ISDN V.110 is equivalent to
the UDI (Unrestricted Digital Informa-
tion) mode found in firmware versions
earlier than V4.0.
Use COORD - Set to YES to include
a GSM station in the search for the
nearest GSM reference station. If
YES is set, coordinates can be
entered and COORD (F2) can be
used to switch between coordinate
systems.
Press CONT (F1) to accept the
settings and return to the station list
and CONT (F1) a second time to
return to panel CONFIGURE\ GSM
Station.
Change the NetDataRate (Network
baud rate) if necessary.