Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 230)

230 7. Measuring with System 500 Technical Reference Manual-4.0.0en
2. Increase the offset and start the
next row in either direction
adjacent to the first grid point.
To use option 1, highlight the Line and
press ENTER. Press PARAM (F5) to
enter the Grid parameters.
Input the new Horizontal Offset (Horz
Offset). Give the Increment (Station
Inc) a negative value. Press CURST
(F4) (current station).
The next target point will be
displayed.
To use option 2, highlight the Line and
press ENTER. Press PARAM (F5) to
enter the Grid parameters.
Input the new Horizontal Offset (Horz
Offset). Press CONT (F1).
The next target point will be
displayed.
The REFLN (F3) key is used to
automatically set the start point of the
reference line as the target. If this is
pressed and the start point has
already been recorded, the end point
will be selected.