Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 314)

314 13. Transfer Technical Reference Manual-4.0.0en
Enables you to convert a Job into an
ASCII file using a Format file. Format
files define the format of the final
ASCII file and are created using Leica
Format Manager software.
13.7 GSI / User
Select From which device you wish to
select a Job and To which device you
wish to store the ASCII file.
The ASCII file can either be written to
the PC-card/ Internal Memory or,
alternatively, to another device via a
serial port.
Job - Select the Job from which you
wish to write the data.
Format - Select the Format File that
you wish to use.
Use SHIFT - LHS (F3) to define the
GSI coordinate switch.
Switch 81/82 - YES activates the
coordinate switch.
Press CONT (F1) to return to the
previous screen.
Format Files need to be stored in the
System RAM of the sensor. Press
FORMT (F3) to transfer them from
the directory \CONVERT of the PC
Card or internal memory to the
System RAM or vice versa.
If PC-card or Internal has been
selected as the desired device you
have to specify the Destination and
the File name:
Destinatn - Select the type of file that
will be written. This specifies where
the file will be written.
File - Specify the file name and
extension.
If To Instrument has been chosen you
have to specify the Port and the
Device.