Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 389)

389 Appendix K Technical Reference Manual-4.0.0en
GIS Navigation/Update:
Chapter 7.5, describing Staking Out,
is similar for most operations. The
small differences are described here.
The PCKUP button is replaced by the
NESTD button, which is also used in
the GIS Data Collection program. It
simply leads to a new data collection
procedure. After data collection is
complete, navigation is continued.
Data Collection with the GS50 and GS50+
Described below are the changes that
refer to data collection with the GS50
/ GS50+.
Due to the different measurement
program, the chapters 7.1, 7.2 and
7.4 are not applicable at all on a
GS50 / GS50+.
The manual “Getting Started with
GS50 / GS50+” is available
describing the GS50 / GS50+ main
programs in detail.
Chapter 7.3 describing realtime
reference station operations is fully
applicable.
OCUPY differentiates if the target
point is taken from a job or from an
ASCII file.
For an ASCII file target point having
no topological information, point data
collection is started to measure the
coordinates and to enter new code
and attribute values.
For a job target point, OCUPY
replaces the old point coordinates
with the new measured coordinates.
SHIFT AUXPT(F5) leading to
auxiliary point stake-out is not
available on GIS Navigation program.