Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 239)

239 8. Coding Technical Reference Manual-4.0.0en
When a Free Codelist has been
selected for use within a
Configuration Set, it will be possible to
record a Free Code when measuring.
The Last Code and second last code
(2Last Code) that were used are
shown.
The CODE (F4) key will be available.
Press this key to access the codelist.
To select the code:
1. Use the left or right cursor keys to
cycle through the code list.
or
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
8.2.3 Adding a Free Code
An asterisk next to a code indicates
that it has attributes.
NEW (F2) lets you add a new code.
LAST (F3) jumps to the code log and
displays the codes that were last
assigned in order.
C-INF (F4) lets you assign new
information blocks to the selected
code.
Press CONT (F1) to select a code
from the list.
Type in the attribute or add a new
attribute with NEW-I (F4).
To add an attribute value to an
existing choicelist of an attribute,
highlight the line of the according
attribute and press ENTER.