Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 241)

241 9. The CONFIG Key Technical Reference Manual-4.0.0en
9. The CONFIG Key
The CONFIG key can be used at any
time to make temporary alterations to
any parameter in the Configuration
Set.
There are some configurable para-
meters that can only be accessed
through the CONFIG key and are not
contained in the sequential
Configuration. Nevertheless, they are
part of the Configuration Set.
The other parameters that are
available through the Sequential
Configuration are described in
Chapter 5.
Press CONFIG.
You can configure any parameter for
the current Configuration Set. You
may make changes to any
configurable option contained in items
1-4. After making the change, you will
press CONT (F1). You will return to
whichever screen you were in
previously. The changes will be
temporary unless, after making the
change, you press the CONFIG key
again and press STORE (F3).
To choose a different Configuration
Set, press CONFG (F5).
You may select any Configuration Set
in the list and press CONT (F1) or
add a new one using the NEW (F2)
key. Press ESC to return to the
CONFIGURE screen.