Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 160)

160 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The Main Survey Panel appears.
From here you can add Point Id, and
Antenna Height and observe the
DOP.
If configured, you will also be able to
add a Code.
If configured, you will also be able to
enter a start time for the point
occupation.
As soon as the receiver has enough
information, the DOP will be
displayed.
7.1.2 Adding the Point Id
The Point Id is an identifier for a
particular point. It also collates all
measurements made on that point
and all other associated data such as
codes, point annotations and
meteorological data.
If a point Id template has been
configured in the Configuration Set, a
Point Id will be suggested. You can
overwrite this with a different Id if
required.
If no point Id is suggested then enter
a point Id. By default if the point Id
contains any numerical values, these
will be incremented by 1.
7.1.1 Overview of Procedure
The Moving Icon is displayed at this
point. This indicates that the Antenna
can be moved around and that no
Static Observations are being
recorded.
Use the OCUPY (F1) key to start data
recording. The icon changes to a
tripod, indicating that the Receiver
should remain stationary.
Press STOP (F1) when you have
enough data and STORE (F1) to
record the point information.
The ADD (F5) key is available in
Advanced mode and is explained in
section 7.1.7.
Further details about this procedure
are given in the sections that follow.