Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 164)

164 7. Measuring with System 500 Technical Reference Manual-4.0.0en
Press STORE (F1) to store the Point
Id and any Thematical Code that you
may have assigned. If Auto Store has
been set in the Configuration, this will
happen automatically.
Leave the survey by pressing SHIFT
followed by QUIT (F6). To switch off,
press the ON/OFF key on the
terminal.
This percentage value is the amount
of data recorded with 100% being the
amount required. If Auto Stop was
selected, the recording of
observations will automatically stop
when 100% is reached.
The ADD (F5) key is available.
Further information is available in the
next section.
Further information about the Stop
and Go indicator, satellites tracked,
data logged etc. can be accessed
through the STATUS key. More
information about this key is given in
Chapter 10.
When the required length of time has
passed, press the STOP (F1) key to
stop raw observation recording. If
Auto Stop has been set in the
Configuration, this will happen
automatically.
Measuring procedure with starting
time
After entering a point ID, the antenna
height and a start time, press the
OCUPY (F1) key.
The line Start Time changes to Time
to go. The time before the
measurement starts automatically is
displayed in hours:minutes:seconds
and is counted down.
Once the entered start time is
reached, the measurement beginns.
The icon changes to a tripod,
indicating that the Receiver should
remain stationary.