Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 372)

372 Appendix J Technical Reference Manual-4.0.0en
This required space will be reserved,
so that it cannot be used by other
applications e.g. standard / primary
logging.
Ring buffer functionality is primarily
designed to be configured using
remote control commands from
external software and this is how
most users will control the ring
buffers. However, it is also possible
to configure ring buffers by using the
TR500 terminal.
Configuring the Ring Buffer
Press the CONFIG button and then
choose 2 Operation and then 6 Ring
Buffer.
Ring Buffer No - Select a ring buffer
to configure. It is possible to config-
ure up to 10 ring buffers. Only one
buffer can be running at one time.
Status - Indicates if the currently
chosen ring buffer is ACTIVE (log-
ging) or INACTIVE (not logging).
Obs Rate - The rate at which obser-
vations will be logged to the chosen
ring buffer. Choose between 0.1s to
60s.
Data Interval - The size of the ring
buffer. This sets the duration for how
long data should be recorded to the
ring buffer before newly observed
data is recorded over the oldest data.
Flag Obs – Defines the dynamic
mode for the selected Ring Buffer.
Choose between Static and Moving.
Device - If the sensor has internal
memory installed then the data
recorded to the ring buffer can be
stored on the sensor internal memory
or the PC-Card.