Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 22)

22 2. Set-up and Connection Technical Reference Manual-4.0.0en
2.2 Equipment Setup - Post Processed Static/Rapid Static/Reference on Pillar
Use
Static/Rapid Static operations or as Reference for Kin-
ematic.
The Receiver and TR500 (if used) can be assembled to
make one unit. One connection is made to the GPS
Antenna which is mounted on the Pillar. The Receiver and
TR500 can be kept in the case. Note that the Receiver
can be programmed with the TR500 prior to use which
can then be omitted from the set up.
Assumptions
1. GPS Antenna is mounted directly using screw fitting.
If using stub and GAD 31 adapter, procedures may
vary slightly.
2. GPS Antennas are AT501 or AT502. Procedures/
setup may vary if AT503, 504 or single frequency
choke ring are used.