Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 247)

247 9. The CONFIG Key Technical Reference Manual-4.0.0en
9.8 General - Identification
The Sensor Identification can be
defined. By default the last four
numbers of the serial number are
used. Type in any other four character
Id if required. The Sensor Id is
displayed in the automatic point
template, log files etc. and defines
which instrument was used for certain
measurements.
Use the DEFLT (F5) key to
automatically redefine the Sensor
Identification as the last four figures
of the serial number.
9.9 Interfaces
Gives an overview of all interfaces
and the port and device currently
assigned for that interface.
For example, a sensor is being used
as a real time rover with a Satelline
radio attached to port 1 and hidden
points are being collected using a
DISTO connected to port 2.
For this type of operation, the
Interfaces panel would look as shown
above.
A more detailed description on the
interfaces is given in the following
sections.
For further details on the interfaces
Tilt and Meteo see App. J.
9.10 Interfaces - Real-Time
The Real-Time interface enables you
to configure the Real-Time
parameters, the port and the device
used for Real-Time data
communication. The port (1,2 or 3)
and the device are displayed. If both
real-time interfaces are configured,
both will be displayed in the
CONFIGURE\ Interfaces panel as
Real-Time 1 and Real-Time 2.
Set the focus on Real-Time and press
EDIT (F3) to modify the Real-Time
device and parameters.
Certain devices allow you to set
additional parameters e.g. channel
switch. This parameters can be
accessed by pressing CTRL (F5). For
information about all supported Real-
Time devices refer to Appendix H.
For information about Real-Time
Reference parameters refer to
section
5.3 Configuring the Receiver for Real-
Time Reference Operations.