Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 344)

344 Appendix H Technical Reference Manual-4.0.0en
Configuring the GSM Phone
From CONFIGURE\ Interfaces
highlight the interface (e.g. Real-
Time) you want to use with a GSM
phone and press EDIT (F3).
Press DEVCE (F5) to access the
device list.
GSM devices are normally used to
transmit or receive Real-Time data.
Additionally a GSM device may also
be used to steer and communicate
with the Sensor e.g. to download raw
data from a remote location etc.
The following standard GSM models
are directly supported with System
500 and fit into a Radio Housing:
Siemens M1
Siemens M20
Siemens TC35
Wavecom WMOD2
Wavecom M1200 Series
The following GSM models are also
supported but do not fit into a hous-
ing:
Bosch 908/909
Sagem MC850
Siemens S25/S35i
Before using GSM phones
for data transmission make
sure your network operator
supports data transmission.
GSM
If you are using a third party
GSM phone make sure it
supports AT command
language. Select a standard GSM phone from
the list.
To select the Bosch 908/909, the
Sagem MC850 or the Siemens S25/
S35i, highlight GSM and press EDIT
(F3). Press OPT (F4). Under Type
select the equivalent GSM.
To define any other GSM device,
highlight GSM and press NEW (F2).
Enter a name (e.g. GSM-XY) and
enter the applicable device param-
eters.
The port settings are the parameters
used for the communication between
the Sensor and the GSM phone. If
required, edit them to suit the GSM
phone.