Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 152)

152 5. Configuring the Receiver Technical Reference Manual-4.0.0en
STOP R-TME - Defines the method
used for Auto Stop when Auto Stop is
set to YES.
When Auto Stop is set to NO a
percentage value will be displayed
next to the Time or Epochs in the
Main Survey screen. This indicates
how much of the Auto Stop criteria
has elapsed. The Auto Stop criteria is
defined using the R-TME (F3) key
(see below).
The criteria available to automatically
stop a real-time Rover are:
Accuracy -Stop when a specified
accuracy is reached.
Positions - Stop after a set number
of positions have been calculated.
Note that these are positions (position
recording rate) and not raw observa-
tions.
STOP&GOIndicator - Stop when the
Stop and Go Indicator has reached
100%.
Auto Store - Will automatically store
the point information and GPS data
when the survey is stopped.
END Survey - Sets how the Survey
operation will be ended. Manual lets
you exit the survey yourself. Auto-
matic will exit the survey automati-
cally. Auto & Shut-down will exit the
survey and turn the sensor off.
Id Templates
You may also configure Id Templates
for Auxiliary Points in exactly the
same way as for normal points.