10 equipment setup - real-time rover, All on pole, direct clip of tr500 on to sensor – Leica Geosystems GPS System 500 - Technical Reference Manual User Manual
Page 48
Advertising
48
2. Set-up and Connection
Technical Reference Manual-4.0.0en
Use
The TR500 is mounted on the Receiver which is clipped
to the grip. Connections are made from the Receiver to
the GPS and Radio Antennas. Recommended for short
periods of use, especially where there are many obstacles
(fences etc.).
Assumptions
1. GPS Antenna is mounted directly using screw fitting.
If using stub and GAD 31 adapter, procedures may
vary slightly.
2. Aluminium poles are used. You may replace them
with their Carbon Fiber equivalents without any
change to these instructions.
2.10 Equipment Setup - Real-Time Rover, All on Pole, direct clip of TR500 on to Sensor
Advertising