Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 377)

377 Appendix K Technical Reference Manual-4.0.0en
Appendix K- GS50 / GS50+ and GIS Data
Collection
Leica GIS
DataPRO
Hardware
GS50 / GS50+
TR500
Antenna
Software
GIS DataPRO
After the data is collected in the field, the GIS DataPRO
office software allows you to import, edit and export the
data to your GIS. The software can also be used to design
codelists which allow you to customize the field data
collection process to suit your needs. To learn more about
the GIS DataPRO office software, please consult the
“Getting Started with the GIS DataPRO Office Software
User Manual”.
GIS DataPRO Post-processing software
GIS DataPRO is used for data collection preparation and
data post processing. Please refer to the “Getting Started
with the GIS DataPRO Office Software User Manual” for
more details.
To install the GIS DataPRO software:
1.
Insert the CD-ROM into the CD drive of your PC.
2. Execute the “Setup” command.
3. Follow the instructions that appear on the screen.
Both a hardware and software user manual can be found
on the CD in PDF format. The software itself contains a
comprehensive online Help System.
Introduction
This appendix describes the operation and data collection
techniques specific to the GS50 / GS50+ and GIS data
collection methods.
This Appendix should be read in parallel with the main
body of this Technical Reference Manual to which the
chapters described below refer.
The Leica GIS DataPRO system is composed of both
hardware and software components.
The hardware consists of the GS50 / GS50+ sensor,
TR500 terminal and antenna. This is used in the field to
collect and record spatial (position) and non-spatial
attributes.