IAI America ERC3 - Manual (Page 95)

Chapter 2 Installation
2.3 How to Install
85
Caution:
• Do not attempt to apply the radial load to the tip of the rod. An operation with the radial load
being applied may cause an abnormal noise or vibration resulted in generation of an alarm.
Also, it may shorten the actuator life extremely.
• Pay attention not to rotate the rod when attaching a load. Make sure to hold 2 faces on the top
with a wrench so the tightening torque would not be applied to the rod.
The allowable static rotation torque
should be 0.5N•m
Radial Load
Between 2
flat faces