Comtech EF Data CDM-570A User Manual

Page 198

Advertising
background image

CDM-570A/570AL Satellite Modem with Optional Packet Processor

MN-CDM570A

Ethernet-based Remote Product Management

Revision 2

7–30

Network Configuration (Typical with or without Packet Processor)

•

IP Address/Mask – Use this field to configure the modem’s Management IP Address.

•

Managed Switch Gateway IP – Use this field to configure this IP Address.

•

Managed Switch MAC Learning (applicable only in Managed Switch Mode) – Use the drop-

down list to select MAC Learning as Enabled or Disabled.

•

Traffic UP Address/Mask (not applicable in Managed Switch Mode) – Use this field to

configure the modem’s Traffic IP Address. Note that this address is assigned automatically

when the modem is running in Managed Switch Mode.

•

MAC Address – This parameter is read-only and cannot be changed.

•

Dedicated Management Port – This feature is available when the optional Packet Processor

is INSTALLED, but it is unavailable when VLAN Mode is Enabled.

Appendix Q. DEDICATED

MANAGEMENT

PORT

FEATURE

•

VLAN – Use the drop-down list to select VLAN Mode as Enabled or Disabled.

Click [Submit] to save.

Port Configuration (with optional Packet Processor INSTALLED)

•

Port – This column identifies the active/available IP ports.

•

Mode and Speed – Use the drop-down list to select the speed for the active port as Auto, 10

Mbps Half Duplex, 100 Mbps Half Duplex, 10 Mbps Full duplex, or 100 Mbps Full Duplex.

Click [Submit Port Cnfg] to save.

•

Actual Negotiated Port Speed – This column identifies the port’s current operational speed

and send/receive settings.

VLAN Brouter (with optional Packet Processor INSTALLED)

VLAN Brouter mode operation is special mode of operation where VLAN traffic is bridged and

non-VLAN traffic in routed using static route table information.

When Brouter mode is used in a hub-spoke network, the remote routers receives the whole

outbound traffic transmitted by the hub. Since VLAN traffic is transmitted to the remote routers

using a broadcast HDLC address, the receiver FPGA in the remote CDM-570A/570ALs will

forward all the traffic to the CPU. In addition to the hub receiving traffic the remote routers

shall also forward the return link (remote to hub) traffic.

•

Typical for VLAN Brouter Mode, VLAN Brouter Tx Payload Compression, VLAN Remote

Mode, and VLAN Filtering – Use the drop-down lists to Enable or Disable operation.

Advertising
This manual is related to the following products: