Appendix c. offset qpsk operation, Appendix c. offset, Qpsk – Comtech EF Data CDM-570A User Manual

Page 457: Operation

Advertising
background image

C–1

Appendix C. OFFSET

QPSK

OPERATION

OQPSK is the acronym for Offset Quadrature Phase Shift Keying modulation. OQPSK is a

variation of normal QPSK that is offered in the CDM-570A/570AL Satellite Modem. Normal

band-limited QPSK produces an RF signal envelope that necessarily goes through a point of zero

amplitude when the modulator transitions through non-adjacent phase states. This is not

considered to be a problem in most communication systems, as long as the entire signal

processing chain is linear.

However, when band-limited QPSK is passed through a non-linearity (e.g., a saturated power

amplifier), there is a tendency for the carefully filtered spectrum to degrade. This phenomenon

is termed spectral regrowth, and at the extreme (hard limiting), the original unfiltered sin(x)/x

spectrum would result. In most systems, this would cause an unacceptable level of interference

to adjacent carriers, and would cause degradation of the BER performance of the corresponding

demodulator.

To overcome the problem of the envelope collapsing to a point of zero amplitude, Offset QPSK

places a delay between I and Q channels of exactly 1/2 symbol. Now, the modulator cannot

transition through zero when faced with non-adjacent phase states; the result is that there is far

less variation in the envelope of the signal, and non-linearities do not cause the same level of

degradation.

The demodulator must realign the I and Q symbol streams before the process of carrier recovery

can take place. For various reasons, this makes the process of acquisition more difficult. In the

CDM-570A/570AL, the two consequences of this are:

1. Demodulator acquisition may be longer than standard QPSK, especially at low symbol rates.

2. The acquisition threshold is slightly higher than for normal QPSK. This effect is only an issue

for LDPC Rate 1/2 and TPC Rate 21/44 code rates, where the Eb/No values are typically less

than 2 dB. In this case, the acquisition and tracking threshold is approximately 1dB higher

than for QPSK.

Advertising
This manual is related to the following products: