Comtech EF Data CDM-570A - Manual (Page 332)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Optional Packet Processor - Serial/Telnet CLI Operation Revision 2
9–36
Selection Hot Key Description
Base [#] B Set a value, from 1 to 249, to display or edit a group of eight of up to 256
definable static ARP entries.
For example, if you want to view or edit static ARP Entries 32-40: Type ‘B’,
and then type ‘32’ to select a Base value of 32. The table will refresh and
display Entry0032 through Entry0040.
9.3.6.3 Protocol Configuration > Brouter Configuration
Open the nested Brouter Configuration page from the Protocol Configuration Page.
Figure 9-23. Brouter Configuration
Selection Hot Key Description
VLAN Brouter Mode B Toggle as [Enabled] or [Disabled]:
When you toggle Enabled, any packet arriving at the Ethernet interface
with a VLAN header is automatically forwarded to the WAN interface. In
this mode ALL VLAN packets are sent – there is no filtering of any kind.
Brouter Mode may be disabled only when both Brouter
Remote Mode and VLAN Filtering are also disabled. If
selection is attempted while either or both of these features
are enabled , the following message displays:
“Disable VLAN-Filter & Remote Mode, And
Then Disabled Brouter Mode”
VLAN Brouter Tx Payload
Compression
P Toggle Payload Compression for all "Brouted" VLAN packets as [Enabled]
or [Disabled].
VLAN Brouter Next Hop
MAC
N On the downlink side, this allows the definition of the MAC of the next hop
router to which all of the Brouted packets must be sent. This permits the
Brouter feature to bypass the need to send an ARP packet for packets that
could potentially have the same IP address.
VLAN Brouter Remote
Mode Enable
R Toggle as [Enabled] or [Disabled].
In this mode, IP traffic received from the WAN interface will not be
forwarded back to the WAN interface, even though the route table
matches.