Comtech EF Data CDM-570A - Manual (Page 202)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Ethernet-based Remote Product Management Revision 2
7–34
7.4.3.3.4 Configuration | Routing Pages
1) These pages are available only to Admin users and when you install the optional
Packet Processor.
2) If you submit any changes to these pages, you must also open the ‘Admin | Pap
Save’ page (see Chapter Sect. 7.4.3.2.7) and immediately click [Save PaP
Parameters].
Click the Routes, IGMP, or DHCP tab to continue.
7.4.3.3.4.1 Configuration | Routing | Routes
Use this page to enter static routes into the Packet Processor to route IP traffic over the satellite
or to another device on the local LAN.
Figure 7-15. Configuration | Routing | Routes Page
Route Table (Edit)
This section displays and allows you to edit all current Route Table entries. From left to right:
Column Description
Index This is the internal table index that is automatically assigned and cannot be edited.
Name This label helps to maintain the network. Enter a label string in this text box. The assigned
name must be unique and cannot contain any whitespace.
Dest.IP/Mask Enter a Destination IP Address/Mask in the form XXX.XXX.XXX.XXX/YY.
Interf. Use the drop-down list to select the Interface as toEth or toSat.
Next Hop IP Enter the desired Next Hop IP Address for toEth routes. Note that no Next Hop entry is
needed for toSat routes.