Comtech EF Data CDM-570A - Manual (Page 326)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Optional Packet Processor - Serial/Telnet CLI Operation Revision 2
9–30
Selection Hot Key Description
Route001 through
Route256 (continued)
o Route Multicast packets from Ethernet to Satellite? [y/n]
Specifies if Multicast packets that match the provided IP address
are routed from the Ethernet to Satellite. “No” means that the
packets are discarded.
o Route Multicast packets from Satellite to Ethernet? [y/n]
Specifies if Multicast packets that match the provided IP address
are routed from the Satellite to Ethernet. “No” means that the
packets are discarded.
Multicast Routes always have a subnet length of 32 and the next
hop is 0.0.0.0 because it is not applicable.
Note: The Packet Processor does allow the specification of one and only
one default route. Destination IP = 0.0.0.0 Subnet Length = 0. The default
route can be defined to send traffic to either the Satellite or Ethernet
interface. This will cause all packets that do not match any other route to be
sent to the destination that has been defined for further processing.
Base [#] B Set a value, from 1 to 249, to display or edit the group of eight of up to 256
definable QoS Routes.
For example, if you want to edit Routes 32-40: Type ‘B’, and then type ‘32’
to select the Base value of 32. The QoS Configuration page will refresh to
display Route032 through Route040.
Delete Route D Set the number of the Route Name (1 through 8) you want to delete.
Display P Displays all of the routes that are currently defined in the system. This
includes automatically generated routes that are provided to simplify
provisioning of the system. The information displayed is: Route Name,
DestIP/Snet Bits, Next Hop, HDLC, and Flags.
PerRoute E Use to enable Header Compression, Payload Compression on a Per Route
basis.
Downlink Mcast [RO] Displays the status of Downlink Multicast as [Enabled] or [Disabled]. This
feature is configured on the Administrator Feature page.