Comtech EF Data CDM-570A - Manual (Page 402)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
CDM-570A/570AL ODU (Transceiver, BUC, LNB) Operation Revision 2
10–28
10.2.2.1.2 ODU | Config Pages
The appearance of the ‘ODU | Config’ page changes depending on which type of
ODU has been recognized via FSK link for operation with the CDM-570A. Use this
page to configure various ODU operating parameters.
10.2.2.1.2.1 ODU | Config (CSAT-5060)
Figure 10-7 shows the ‘ODU | Config’ page as it appears with the CSAT-5060 configured as the
ODU. Use this page to configure the primary CSAT-5060 Transmit and Receive Parameters.
Figure 10-7. ODU | Config page (CSAT-5060)
ODU Selection
When using redundant ODUs, you may toggle the page between the Online and Offline units by
selecting CSAT #1 or CSAT #2, and then clicking Select ODU. A message identifies the active unit
as ‘ONLINE’ in the right-hand side of the box.
Upconverter Parameters
• Frequency – Enter a value in MHz.
• Attenuation – Enter a value in dB.
• Slope Mode – Select Manual or Calibrated from the drop-down list.