Comtech EF Data CDM-570A - Manual (Page 342)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Optional Packet Processor - Serial/Telnet CLI Operation Revision 2
9–46
Selection Hot Key Description
Recenter Rx Buffer C Select to force re-centering of the Plesiochronous/Doppler buffer.
Rx Clock Inversion A Select the Rx clock inversion type:
1 – Normal
2 – Inverted
Rx Filter Rolloff E Select the Rx alpha filter rolloff:
1 – 0.35
2 – 0.25
9.3.8.1.3 Satellite Modem > Configuration > Framing Mode Configuration
Open the nested Framing Mode Configuration page from the Configuration page.
Figure 9-29. Framing Mode Configuration
Selection Hot Key Description
Framing Mode F Select the Framing Mode:
1 – Unframed
2 – EDMAC Framing
3 – EDMAC-2 Framing
EDMAC Mode D Select the EDMAC Framing Mode:
1 – Unframed
2 – EDMAC Framing
3 – EDMAC-2 Framing
EDMAC Slave Address Range V Set a value from 10 to 9990 in multiples of ten.
AUPC A Select the AUPC operation:
1 – Enable
2 – Disable
Max Power Reached Action R Select the action:
1 – No_Action
2 – Generate_TX_Alarm
Remote Demod Unlock Action U Select the action:
1 – Nominal_Power
2 – Maximum_Power
Target E
b
/N
0
of Remote Demod
(db)
E Set a value from 0.0 to 9.9.
Maximum Power Limit M Set a value from 0 to 9.