D.1 overview – Comtech EF Data CDM-570A User Manual

Page 459

Advertising
background image

D–1

Appendix D. OPTIONAL

HIGH PERFORMANCE PACKET

PROCESSOR

D.1 Overview

The High Performance Packet Processor is available as a factory-installed option or

as a field-upgradeable option (see Sect. D.1.1.3).

The optional High Performance Packet Processor makes the CDM-570A/570AL a high-

performance, low-cost, IP-centric satellite modem that is well-suited for point-to-point and

point-to-multipoint applications.

(This appendix identifies this optionally-equipped modem as the CDM-570A/570AL-IP. The

CDM-570A/570AL-IP and other compatible, IP-centric Comtech EF Data modems may also be

generically referred to throughout this appendix as the CDM-IP.)

In addition to providing both Layer 2/Layer 3 functionality, the CDM-570A/570AL-IP

incorporates a number of key features for Wide Area Network (WAN) bandwidth optimization,

including Header Compression, Payload compression, and Advanced Quality of Service (QoS).

The CDM-570A/570AL-IP enables efficient IP networking and transport over satellite, in either

Router Mode or Managed Switch Mode, by adding routing capability with very low overhead

encapsulation, header compression, payload compression, and Quality of Service (QoS). The

Advanced QoS combined with header and payload compression ensures the highest quality of

service with minimal jitter and latency for real-time traffic, priority treatment of mission critical

applications and maximum bandwidth efficiency.

The CDM-570A/570AL-IP can be used in a Vipersat Management System (VMS).

Vipersat CDM-570/570L Satellite Network Modem User Guide (CEFD P/N

MN/22125)

Advertising
This manual is related to the following products: