Comtech EF Data CDM-570A - Manual (Page 286)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Serial-based Remote Product Management Revision 2
8–46
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
Faults and
Status (continued)
b = Tx Traffic status:
0 = Tx traffic OK
1 = No clock from terrestrial interface
2 = Tx PaP ETH Link Down
3 = Tx FIFO slip
4 = G.703 Loss of Signal (valid only in Clock Extend Mode)
5 = Loss of External Reference
6 = Reserved
7 = AUPC upper limit reached
8 = Reserved
9 = AIS detected on incoming data
A = Reserved
B = Bipolar violation on G.703 interface
C = Reserved
D = Reserved
E = Reserved
F = BUC Alarm (if attached)
c = Rx Traffic status:
0 = Rx Traffic OK
1 = Demodulator unlocked
2 = Reserved
3 = AGC Alarm - signal out of range
4 = Reserved
5 = RS Frame sync alarm
6 = Reserved
7 = EDMAC Frame sync alarm
8 = APC Band mismatch alarm
A = Buffer Underflow
B = Buffer Overflow
D = Eb/No alarm
E = LNB Alarm (if attached)
F = AIS detected on incoming data
9 = Reserved
A = Buffer Underflow
B = Buffer Overflow
C = Reserved
D = Eb/No alarm
E = LNB Alarm (if attached)
F = AIS detected on incoming data