Comtech EF Data CDM-570A - Manual (Page 213)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Ethernet-based Remote Product Management Revision 2
7–45
• Protocol / Priority / WRED / Filtering – Use the drop-down list to select the desired
operational state.
• Src IP Mask / Dst IP Addr and Mask / Min and Max Src Port / Min and Max Dst Port / Max
BW (Kbps) – Entire the desired parameter as needed.
Click [Add Rule] to save. When you add a new rule to the QoS Max/Priority Rules Table, the
modem automatically assigns an internal table index number.
Delete Rule
Enter Rule Index to Delete, and then click [Delete Rule] to execute removal of the specified rule
from the QoS Min/Max Rules Table.
The information that follows is applicable only when QoS Mode = DiffServ Mode
QoS DiffServ Rules Table
This section displays all existing QoS DiffServ (Differentiated Services) Rules Table entries. From
left to right:
Column Description
Index This is the internal table index that is automatically assigned and cannot be edited.
Class Specifies the DSCP Class Selector Precedence type (Expedited Forwarding, Assured
Forwarding, etc.)
DSCP Specifies the Class Selector DiffServ Code Point (DSCP) value in the Type of Service (ToS)
byte within the IP header .
Min Bw (kbps) Specifies the Minimum Bandwidth value in kilobits per second.
Max Bw (kpbs) Specifies the Maximum Bandwidth value in kilobits per second.
Max Bw (%) Specifies the Maximum Bandwidth (%) value. This is useful where the uppermost bandwidth
limit must be scaled as a percentage of the Tx bandwidth of the modem, when the modem
bandwidth changes over time due to ACM or dSCPC in Vipersat Mode
Priority Specifies the priority established for the specific rule (1-8).