D.2.6.1 configure user pcs, D.2.6.2 set cdm-ip modems to router mode operation – Comtech EF Data CDM-570A User Manual
Page 486
CDM-570L/570AL Satellite Modem with Optional Packet Processor
MN-CDM570A
Appendix D
Revision 2
D–28
D.2.6 Configuring a Router Mode Point-to-Point System
The procedures outlined in this section result in the configuration shown in Figure D-4.
Figure D-4. Router Mode Point-to-Point System Configuration
D.2.6.1 Configure User PCs
Do these steps:
Step Task
1
For User PC 1:
•
Set the IP Address to 172.17.10.11;
•
Set the mask to 255.255.255.0;
•
Set the PC Gateway IP Address to 172.17.10.1.
2
For User PC 2:
•
Set the IP Address to 172.16.10.11;
•
Set the mask to 255.255.255.0;
•
Set the PC Gateway IP Address to 172.16.10.1.
3
Reboot the PCs (if required).
D.2.6.2 Set CDM-IP Modems to Router Mode Operation
Do these steps on CDM-IP 1 (the applicable CLI “hot key” is shown in brackets [#]):
Step Task
1
From the CLI Main Menu:
Select the Administration [A] submenu.
2
From the Administration menu:
Select CDM-IP Working Mode [C].
3
When the following prompt is displayed:
Changing Modem working mode requires system Reboot.
Do you want to continue(Y/N)[Enter :No]