Comtech EF Data CDM-570A - Manual (Page 303)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Optional Packet Processor - Serial/Telnet CLI Operation Revision 2
9–7
9.3 CLI Operations
Figure 9-2 show use of HyperTerminal as configured for Telnet CLI. The appearance
of this interface may vary across individual user configurations. The remainder of
this chapter shows the CLI pages as they appear with any user-supplied terminal
emulator.
9.3.1 CLI Main Menu
Figure 9-2. Main Menu
Selection Hot Key Description
Administration A
Provides a basic set of standard administrative functions to the
Packet Processor. When connected via Telnet, navigation to this
menu is restricted to the Admin user.
Interface Configuration I Configures the Ethernet and Satellite interfaces.
QoS Configuration Q Defines QoS rules for up to 32 different types of flows.
Route Table R
Defines how the Packet Processor will route packets that it receives
on its Ethernet and Satellite interfaces.
Protocol Configuration P
Configures various protocols – including ARP, IGMP, DHCP, and
BRouter – used by the Packet Processor.
Satellite Modem Configuration M
Displays menus that are used to configure and monitor the Base
Satellite Modem.
Redundancy Configuration E Configures 1:1 IP Redundancy.
Operations and Maintenance O
Configures various options for system control and maintenance;
provides Statistics and diagnostic tools for troubleshooting purposes.