H3C Technologies H3C Intelligent Management Center User Manual
Page 329
319
10.
To include traffic from the hosts and applications you specify in a business service, select Include
from the IP Stat. Direction list. To exclude traffic from the hosts and applications, select Exclude.
You can add one or more IP hosts or IP address ranges to a traffic analysis task. However, you
must have at least one host defined, and no more than 10 host entries defined for each task. You
can add multiple businesses in a traffic analysis task.
You can configure a traffic analysis task to include traffic for one or more hosts defined by IP
address. Alternatively, you can enter a range of IP addresses to be included in the analysis, or you
can enter a combination of IP host addresses and IP address ranges. However, no two addresses
or address ranges entered in the Host IP field can overlap.
11.
Add IP address entries in the Host IP field. To enter the IP address for a single host, use dotted
decimal notation.
An example of a valid IP address entry is as follows:
10.153.89.10
An example of a valid network/subnet mask in dotted decimal notation is as follows:
10.153.89.0/255.255.255.0
An example of a valid network/subnet mask entry using CIDR notation is as follows:
10.153.89.0/24
An example of a valid IPv6 address entry is as follows:
a001:410:0:1::1
An example of a valid IPv6 address and subnet mask using CIDR notation is as follows:
a001:410:0:1::1/64
12.
Click the Add button to the right of the Host IP field.
The addresses and masks you entered are added to the Host IP List field below the Host IP field.
13.
To add applications to the task, click the Add button next to the Application List field.
The Query Applications dialog box is displayed, and an empty Application List is displayed in the
lower portion of the dialog box.
To select applications to add to the task, you must first query the Application List as follows:
a.
Enter one or more of the following search criteria in the Query Applications area of the dialog
box:
Application—Enter the partial or complete name of each application you want to search for.
Pre-defined—To search for applications that are predefined, select Yes. To filter for
applications that are user defined, select No. To include both predefined and user-defined
applications, select Not limited.
To display the complete Application List, click Query without entering any search criteria.
b.
Click Query to begin your search.
The results of your query are displayed in the Application List below the Query Applications
area.
c.
Select the check boxes next to the applications you want to add to the task.
d.
Click OK to add the applications to the task you want to create.
The applications are displayed in the Application List.