32 sdma debug module status register-mbar + 0x127c, Section 13-36, sdma debug module status register – Freescale Semiconductor MPC5200B User Manual
Page 460
BestComm DMA Registers—MBAR+0x1200
MPC5200B Users Guide, Rev. 1
Freescale Semiconductor
13-27
It must be noted that even if a breakpoint is issued at a specific address the SDMA engine will halt ONLY at a “data aligned” boundary (for
instance, if the task moves 32 bits of data per transaction and a breakpoint is set at address 0x02 then the task will be halted at offset 0x04).
13.15.32 SDMA Debug Module Status Register—MBAR + 0x127C
Table 13-35. EU Breakpoint encoding
EU3
EU2
EU1
EU0
Reset
0
0
0
0
Table 13-36. SDMA Debug Module Status Register
msb 0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
R
Reserved
I
E
T
W
RESET:
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31 lsb
R
dbgStatusReg[15:0]
W
RESET:
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Bit
Name
Description
0:12
Reserved
Reserved
13
I
Interrupt—This bit indicates whether or not an interrupt has been taken. This bit is set to 0
at reset. It can be written by the user or the SDMA engine.
0 No Interrupt
1 Interrupt taken
14
E
External Breakpoint—This bit indicates detection of an external breakpoint. Status bit is
sticky and requires a one (1) to be written to it to clear it. The writing of a zero (0) to this bit
has no effect. This bit is set to zero (0) at reset.
0 No external breakpoint detected
1 External breakpoint detected
15
T
Triggered (dbgStatusReg[16])—This bit indicates that a SmartDMA breakpoint has
occurred with the current settings. Status bit is sticky and requires a one (1) to be written
to it to clear it. The writing of a zero (0) to this bit has no effect. This bit is set to zero (0) at
reset.
0 Armed or normal operation
1 Triggered or debug mode
16:31
dbgStatusReg[15:0] dbgTaskBlock (dbgStatusReg[15:0])—Each bit corresponds to one of the 16 task numbers.
The value of the register bit reflects the debug state of the task number. A bit is cleared by
writing a one to that bit location; writing a zero (0) has no effect. At system reset, all bits
are initialized to logic zeros (0).
0 Unblocked or normal operation
1 Blocked, task has been blocked due to a breakpoint