Freescale Semiconductor MPC5200B - Manual (Page 475)

MPC5200B Users Guide, Rev. 1
14-10 Freescale Semiconductor
FEC Registers—MBAR + 0x3000
14.5 FEC Registers—MBAR + 0x3000
The FEC uses 37 32-bit registers. These registers are located at an offset from MBAR of 0x3000. Register addresses are relative to this offset.
Therefore, the actual register address is
MBAR + 0x3000 + register address
Hyperlinks to the FEC registers are provided below:
290 RMON_R_CRC_ALIGN RMON Rx Packets with CRC/Align error
294 RMON_R_UNDERSIZE RMON Rx Packets less than 64Bytes, good CRC
298 RMON_R_OVERSIZE RMON Rx Packets greater than MAX_FL bytes, good CRC
29C RMON_R_FRAG RMON Rx Packets less than 64Bytes, bad CRC
2A0 RMON_R_JAB RMONRxPackets greater than MAX_FL bytes, bad CRC
2A4 RMON_R_RESVD_0 Reserved
2A8 RMON_R_P64 RMON Rx 64Byte packets
2AC RMON_R_P65TO127 RMON Rx 65 to 127Byte packets
2B0 RMON_R_P128TO255 RMON Rx 128 to 255Byte packets
2B4 RMON_R_P256TO511 RMON Rx 256 to 511Byte packets
2B8 RMON_R_P512TO1023 RMON Rx 512 to 1023Byte packets
2BC RMON_R_P1024TO2047 RMON Rx 1024 to 2047Byte packets
2C0 RMON_R_P_GTE2048 RMON Rx packets with greater than 2048Bytes
2C4 RMON_R_OCTETS RMON Rx Octets
2C8 IEEE_R_DROP Count of frames not counted correctly
2CC IEEE_R_FRAME_OK Frames received OK
2D0 IEEE_R_CRC Frames received with CRC error
2D4 IEEE_R_ALIGN Frames received with alignment error
2D8 IEEE_R_MACERR Rx FIFO overflow count
2DC R_FDXFC Flow Control Pause frames received
2E0 IEEE_R_OCTETS_OK Octet count for frames received without error
2E4–2FC rsvd Reserved
300–3FF rsvd Reserved
Table 14-8. MIB Counters (continued)
Address Mnemonic Description