Toa N-8000 Series - Manual (Page 101)

1-84
Chapter 1 GENERAL DESCRIPTION
10.1. Message Recording
• Use the N-8000 Setting Software to record the Message
on a PC and program it into the IP Master Station or the IP
Remote Microphone Station from the PC.
• Messages of up to 20 seconds in length can be recorded
and programmed.
10.2. Programmed Message Confirmation
Messages programmed into the IP Master Station or the IP Remote
Microphone Station can be confirmed at that station. To confirm it, press the
Paging Call key when the IP Master Station or the IP Remote Microphone
Station is in standby mode, then press the Paging Response key.
10.3. Initiating Message Pagings
10.3.1. Startup method
The following two startup methods are available:
(1) Pressing the IP Master Station's or the IP Remote Microphone Station's Paging Call key four times in rapid
succession initiates the Message recorded on that station.
PC installed with N-8000
Setting Software.
Emergency situation.
Emergency situation.
Emergency situation.
Message paging
initiated.
Note
The Message paging cannot be initiated when the IP Master Station or the IP Remote Microphone Station to
be operated is currently in use. Wait until the station is in Standby mode. An exception to this is priority given
to Message pagings initiated at an IP Master Station that is receiving a paging call in the system set for Call
Priority mode. (Refer to the next page .)