Toa N-8000 Series - Manual (Page 144)

2-33
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
4. BROADCAST TO SX-2000 SYSTEM
(N-8600MS only, only when SX-200IP is used)
4.1. Selected Zone Broadcast
Broadcasts can be made to the zone(s), or zones assigned to a zone pattern* 1 within the SX-2000 system area.
Broadcast durations can be limited by preprogramming the time limit (between 1 and 20 minutes in 1-minute
units) for each station.
* 1 A pattern into which multiple zones are grouped.
Notes
• Perform zone pattern settings using the N-8000 Setting Software. You can also import and use the output
zone pattern having been set on the SX-2000 Setting Software. (Refer to p. 5-77 .)
• Set the time limit (Time out) using the supplied N-8000 Setting Software. (Refer to p. 5-72 .)
Step 1. Press the Paging key.
Step 2. Select a zone.
Multiple zones or zone patterns can be sequentially selected by repeating the key operation in the
following step 2-1 or 2-2.
Note
The maximum number of digits for zone selection dial is 380.
2-1. When selecting a zone
Press the following keys in order.
2-2. When selecting a zone pattern
Press the following keys in order.
Step 3. Press the [ ] key.
A chime tone is transmitted to the selected zone(s).
Step 4. Page with the handset either lifted or in place.
Step 5. Either press the Clear key or replace the handset.
A chime tone is transmitted to the selected zone(s), then paging is completed.
Notes
• Set the SX-2000 system ID using the supplied N-8000 Setting Software. (Refer to p. 5-28 .)
• Chime tone can be set to OFF. (Refer to p. 5-72 .)
X X Y Y Y
SX-2000 system ID
number (01 – 08)
SX-2000
zone number* 2 (001 – 256)
* 2 Z one numbers are assigned as shown in
the table below.
Zone
No.
SX-2000AO's
unit No.
SX-2000AO's
audio output
terminal No.
001 1 1
002 1 2
... ... ...
008 1 8
009 2 1
... ... ...
256 32 8
X X Z Z Z
Zone pattern number* 3
(001 – 216)
SX-2000 system ID
number (01 – 08)
* 3 The pattern number having
been set using the N-8000
Setting Software.