Toa N-8000 Series User Manual
Page 347
3-43
Chapter 3
INSTALLATION & WIRING
N-8650DS
Panel mount frame
Screw
Screw hole
Bottom view
Tab
YS-13A
Install the YC-13A with its
bottom plate removed.
Rear plate
Wall surface
Panel mount frame
Machine screw M4 x 20 (supplied with the N-8650DS)
[N-8650DS]
Attach the N-8650DS to the YS-13A Wall-mount box installed on a wall.
Step 2. Mount the panel mount frame to the back
box.
Step 3. Attach the N-8650DS to the panel mount
frame.
Hook the tabs on the N-8650DS's upper side
into the panel mount frame's slots, fit them
into place, then secure the both bottom sides
with a screw.
Note
Treat unused cables so as not to short-circuit.
Tip
Refer to
for YS-13A dimensional drawing.
The N-8650DS comes with 2 types of screws: M4 x 20
and UNC No. 6-32 x 20. Use the M4 x 20 screw.
Accessory screws
Step 1. Loosen the screw on the N-8650DS's bottom, then detach the panel mount frame.
N-8650DS's bottom
Screw
Panel mount frame