Toa N-8000 Series - Manual (Page 255)

2-144
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
3.1.2. Selectable paging
Paging calls can be made to up to 50 preprogrammed zones.
Use the supplied N-8000 Setting Software to set the paging zones. (Refer to p. 5-121 .)
Step 1. Lift the handset, then press the [ ][8][ ] keys, followed by the desired paging zone number (1 − 192).
Note
Enter a zone number with the digit length (1 − 3 digits) set with the N-8000 Setting Software.
Step 2. To select the zone numbers consecutively, press the [ ] key.
Step 3. To terminate the zone selection, press the [#] key following the zone number.
A paging tone is sounded in the selected zone(s).
Step 4. Page with the handset.
Note
If the system's paging response mode has been set for Zone number designation response (refer to
p. 2-32 .), announce the response zone number (any one of the paged zones) in the paging message.
Step 5. Replace the handset.
The paging is completed.
0 5
8 0 0 1
1
2 0 3
Zone 1
Amplifier
Speakers
No. 1000 No. 1002 No. 1003 No. 1004
Zone 23
No. 2000
Zone 105
Amplifier
Speaker
1~3
5
4
(Zone number with 3-digit length)
[Example paging to the zone 1, 23, and 105.]